Installing a garage door keypad is a great way to add an extra layer of security to your home while also providing the convenience of being able to open the garage door without the need for a physical key or remote. In this article, we will walk you through the process of installing a garage door keypad, including what tools and materials you will need and the steps involved.
Before you begin, you will need to gather the following tools and materials:
- A garage door keypad
- A drill and drill bits
- A screwdriver
- A level
- Wire stripper
- Electrical tape
Step 1: Locate the control box
The first step in installing a garage door keypad is to locate the control box for your garage door opener. This is typically located near the garage door opener itself, and it is where the wiring for the opener is located.
Step 2: Disconnect power
Before you begin working on the control box, it is important to disconnect the power to the garage door opener. This can typically be done by unplugging the opener or turning off the power at the circuit breaker.
Step 3: Remove the control box cover
Once the power is disconnected, you can remove the control box cover to access the wiring. This is usually done by removing a few screws or by sliding the cover off.
Step 4: Identify the terminals
Inside the control box, you will find a number of terminals. These terminals are where the wiring for the opener is connected. You will need to identify the terminals that are used to control the opener.
Step 5: Wire the keypad
Once you have identified the terminals, you can wire the keypad to the control box. This will typically involve running a pair of wires from the keypad to the terminals on the control box. Use wire stripper to strip the wires.
Step 6: Mount the keypad
With the wiring complete, you can now mount the keypad to the wall. The keypad will typically come with mounting hardware and a template for drilling the holes. Use a level to ensure that the keypad is mounted level.
Step 7: Test the keypad
After the keypad is mounted, you can reconnect the power to the opener and test the keypad. Press the button and see if the door is working properly.
Step 8: Program the keypad
Once you have confirmed that the keypad is working properly, you can program the keypad with a code. This will typically involve entering a default code, and then changing it to a code of your choice. Follow the manufacturer’s instructions to program the keypad.
Step 9: Secure the control box
With the keypad installed and programmed, you can secure the control box by replacing the cover and securing it with the screws.
In conclusion, installing a garage door keypad is a great way to add an extra layer of security to your home while also providing the convenience of being able to open the garage door without the need for a physical key or remote. The process is relatively simple, and can be done by most homeowners with a basic set of tools. However, if you are not comfortable working with electrical wiring, it may be best to hire a professional to install the keypad for you.